What did you do to your 2002 today !

[Fawudd]

Went for a 35 mile drive today. Significant in that it was the longest drive For this car In 6 years . There are still many things to sort out, But the ability to drive the car Is a milestone . 

[Steve Tochi]

We had a playdate with his 630HP friend. I was proud of her, never backed down from that Chevy and said lets take it to the mountain roads....where gas stations are few and far between. Seriously, nice Chevelle down to the fuel pump...has anyone every seen a polished KF?

 

[Mike G]

Front end is back together and ready for the motor to come off the stand. 

[tzei]

Drive shafr came from the shop. Shortened to fit with Samsonas and new joints + balanced. Front struts are ready to fit the car. New for this season: m10 12.9 bolts to fasten steering arms.

[Tommy]

Hmm tzei, sure the wheel studs are tall enough?  ?

 

Drive shaft looks about the same what mine forms up for F20C. So tempted to try one-piece again. It would be about 20cm taller than S2000 stock one-piece shaft...

[Mario Falfan]

My dash was looking tired and filled, so I went into the garage and got my bottle of Forever Black and a clean sponge and applied it on my non-cracked dashboard and after 3 coats I was very pleased with the end result.

[irdave]

5 hours ago, tzei said:

... Samsonas ...

 

Mmmmmmm....

[evil02]

5 hours ago, tzei said:

Drive shafr came from the shop. Shortened to fit with Samsonas and new joints + balanced. Front struts are ready to fit the car. New for this season: m10 12.9 bolts to fasten steering arms.

 

Nice!!  Seems you have a lot of spacer for roll center correction. How short are your struts?

 

Dave

[Mario Falfan]

Ordered and received the trim from rogerstii and replaced it...afterwards applied some Forever Black on the non-cracked dash and loved the end result.

Edited March 22, 2019 by Mario Falfan
Mispelled

['76mintgrün'02]

17 minutes ago, Mario Falfan said:

 

 

FWIW, I added sound dampener to the back of the plastic hinge covers, because I didn't like the sound they made when the seat belt receivers hit them.  Did the same thing to the shifter surround.  (in part because that stuff is fun to work with)

 

[PaulTWinterton]

3 hours ago, Mario Falfan said:

my non-cracked dashboard

 

That's pretty boastful!

 

 But I would boast too...if I had a crackfree dash. ?

[tzei]

2 hours ago, evil02 said:

How short are your struts?

378 mm. Strut bottom to outer ball joint (centre) is about 90 mm.

[evil02]

21 minutes ago, tzei said:

378 mm. Strut bottom to outer ball joint (centre) is about 90 mm.

 

 You must run pretty low?   How heavy are your springs and about how much travel do you think you use?

[tzei]

1 hour ago, evil02 said:

You must run pretty low?   How heavy are your springs and about how much travel do you think you use?

Ground clearence is MOT required minimum 90 mm (rules allows 50 mm). Mains are 110 Nm atm. Travel is 50-60 mm? Idk for sure.

[tzei]

There. Left side ready.