engine and drivetrain Need help to identify Weber Carb

[sotnaso]

Newbie here.  I need help to identify which Weber carburetor this is.  Recently bought an 02 and this was installed.  I'm not sure if this is aftermarket or oem.  I can't find identifying stamp on the carb.  Any help is appreciated

[halboyles]

It appears to be a standard 32/36 but look at the base of the carburetor on the driver's side.  It will be beneath the air cleaner support.  The model number should be stamped on the lower base of the carb.

[AceAndrew]

Any weber on an 02 is aftermarket.  As Hal says, you've got a water-choke 32/36.

Edited October 19, 2016 by AceAndrew

[sotnaso]

Thank you halboyles and AceAndrew for the info.  I probably need to clean the base to be able to see the stamped model number.  

[Roundeie]

Thank you halboyles and AceAndrew for the info.  I probably need to clean the base to be able to see the stamped model number.  

And take off the air cleaner support.


Sent from my iPhone using Tapatalk

[sotnaso]

8 hours ago, Roundeie said:

And take off the air cleaner support.


Sent from my iPhone using Tapatalk

Is the air cleaner support the one that is fastened by the four allen  screws?

[Conserv]

6 hours ago, sotnaso said:

Is the air cleaner support the one that is fastened by the four allen  screws?

 

Yes, it theoretically permits the factory air cleaner housing to fit onto the aftermarket Weber, but....it's often too high and dents your hood!  There are long -- good -- threads on adapting the factory air cleaner housing to Weber carbs, without denting your hood.

 

Regards,

 

Steve

 

EDIT:  Oh, I see, the reference is not to the air cleaner housing adapter (four Allen screws) but to the outriggers that originally supported the housing!  Sorry if I made this more confusing.

Edited October 19, 2016 by Conserv

[Arizona02]

Weber  carb   id     http://www.carburetion.com/CarbID/weberID.htm

[Buckeye]

You have got a 32/36 DGAV (Water Choke)

12 hours ago, Roundeie said:

And take off the air cleaner support.
 

 

Save your Weber adapter, original air cleaner housing and support brackets. Combination of Weber carburetor 32/36 with original air cleaner housings that is tied to Air Regulator Housing is great set up for std. car.

[sotnaso]

Thanks for all the help.  It is in fact 32/36.  Learned something new.

[EuroOhTwo]

I have the exact same carb/setup on my '73 stock '02. No problems with rubbing on the hood. As you can see from attached pic, there is a small rubbing on the hood liner when I inadvertently didn't push the air cleaner housing down fully on the rubber adapter. But no actual contact/denting of hood when installed correctly.

...George

 

Edited October 21, 2016 by EuroOhTwo
tect/pic conflict