Jump to content
revolve40

Weber DCOE: Ditching Soft Mounts

4 posts / 214 viewsLast Reply

Recommended Posts

I am ditching my soft mounts in favor of this mounting block/gasket set from Pierce. Is there a specific installation procedure including any need for sealant or torque spec or just snug them up with washers and nylock nuts? I hope I only have to do this once...

 

z70-216-2.jpg

 

Thanks!

Share this post


Link to post
Share on other sites

Yes gasket on ether side of the spacer block, washers and loc-nuts, run all 4 nuts on each carb down evenly then snug them down moderately tight, no sealer unless the mounting faces are scratched deeply.

  • Like 1

Share this post


Link to post
Share on other sites

Also, recheck for tightness occasionally. 

 

Some OEMs used an outer support on the carbs to help reduce flexing

loads on the mounts....  because the spacers tend to get compressed on

the bottoms, then leak.

 

t

 

  • Like 2

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.




×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.