I can not find the floor pans I need!!

[Dejammey]

So I am looking for a drivers side floor pan that goes up into the pedal box area.

I looked at jaymic.com and theirs only is for the floor.

Does anyone know of a place to get the full floor pan?

[Kpeters]

We can source floor pans but to be honest can't remember if they went that high let me check and get back.

[Dejammey]

Thanks man

[zippy500]

I have got the same problem,

Think I am just going weld the floor pan in to where it ends then just try and make something to fit.

I think you are heading in to bulkhead area. not sure

[Kpeters]

Hopefully later today or tomorrow I'll have an answer!

[Kpeters]

Well looking at the diagrams the do come up to the pedal box but I can't tell exactly how much. If you want to see the diagram please give me your email and I'll forward it to you.

Konrad.

[Dejammey]

Well looking at the diagrams the do come up to the pedal box but I can't tell exactly how much. If you want to see the diagram please give me your email and I'll forward it to you.

Konrad.

Thanks man my Email is Chad Byrum @ gmail.com could you send me the price too?

[stymee]

The floor pan offered by Walloth & Nesch (in germany) worked great for me.

1 41 11 1 430 001 floor repair sheet all types front left

You can find it on their website (just browse to 2002 parts, bodywork):

http://www.wallothnesch.com/e/frameparts.htm

Shipping from germany was surprisingly quick and not that expensive.

Here's a shot of mine when I was welding it in. You can see that it stops just at the bottom of the pedal box. I haven't seen any repair panels for the area that surrounds the pedal box.

I was so happy with the front floor piece that I bought both rears and was, again, very happy with the quality and fit. Check out my thread if you want to see an epic battle with rust (I think I'm winning).

http://www.bmw2002faq.com/component/option,com_forum/Itemid,0/page,viewtopic/t,354332/start,0/postdays,0/postorder,asc/highlight,/

Good luck!

[dlmrun2002]

Nice. job there. What welder are you using? I picked up 4 panels from them years ago...just in case..

Doug M ny country

[zippy500]

Nice job, did you butt weld the joints or lap weld

[stymee]

I apologize for the thread jack. I use a little Lincoln Electric Handy Mig, works great on sheet metal. Those are all butt welds.

[Kpeters]

Email sent.