3 bolt front half of driveshaft (for 5 speed conversion)

[doslucero]

Price: $60

Location: Phoenix, AZ

Description:

This front half of a driveshaft came from a 86 3 series.  I was planning on cutting the side with the 3 bolt flange and having it welded to my 2002 driveshaft in order to mate to the 5 speed transmission but my 2002 driveshaft needed new joints so I decided to buy a full driveshaft from IE.  I found this 3 bolt front half driveshaft at a salvage yard.  I got taken for $100 but will let it go for $60 plus shipping.  

 

Thanks,

Roberto 

[halboyles]

Do you also have the rear half?

[doslucero]

6 minutes ago, halboyles said:

Do you also have the rear half?

I do not because I sent in my full 2002 driveshaft as a core for the new one I'm ordering.  I do however have a full driveshaft from a 1979 bmw 320i.  Not sure if that's of interest to you.  

[halboyles]

2 minutes ago, doslucero said:

I do however have a full driveshaft from a 1979 bmw 320i.

 

I actually need the version that you have the front half for.  Thanks anyway.

[doslucero]

6 minutes ago, halboyles said:

 

I actually need the version that you have the front half for.  Thanks anyway.

Sorry,  left that in the salvage yard. 

[2double02]

Forgive me if this is a dumb question, but is the e30 driveshaft diameter the same as a 2002s so that the end can be removed and easily re-welded?

[doslucero]

31 minutes ago, 2double02 said:

Forgive me if this is a dumb question, but is the e30 driveshaft diameter the same as a 2002s so that the end can be removed and easily re-welded?

Yes.  I measured it.  It is 50mm.  Same as a 2002 driveshaft. 

[reyes02]

IE has 240g conversion driveshafts?!


- Reyes

[doslucero]

11 minutes ago, reyes02 said:

IE has 240g conversion driveshafts?!


- Reyes

No, I had to give them the measurements so they could cut a driveshaft to the correct length.  They do however sell a 2002 driveshaft ready to go for a getrag 245 but I'm guessing you already knew that. 

[reyes02]

Mind sharing the measurements you’ve taken, I also need one. Haven’t had time to get it done.


- Reyes

[doslucero]

22 minutes ago, reyes02 said:

Mind sharing the measurements you’ve taken, I also need one. Haven’t had time to get it done.


- Reyes

Sure man.  I actually made a graphic with the measurements I got.  

 

Driveshaft Length2.pdf

[doslucero]

[jgerock]

Pm sent