After a month, it's on the road again.....

[Lars]

Finally got time to replace that timing chain cover, no more oil leaks (from there). But this morning, when looking for the source of some fluid that I saw on the ground last night (coolant I believe) I saw were my brake fluid was going. There was a small bit right under the clutch slave cylinder. So it looks like that is the next thing to be done. How hard or easy of a job is it? This is yet another thing I've never done. Any special tools required?

[jlandreth]

It's not hard unless it's seized in the bellhousing.Snap ring pliers are required

[robspeed]

It's not hard unless it's seized in the bellhousing.Snap ring pliers are required

i forget, you dont have to remove the tranny do you? I did mine with the trans sitting on garage floor. (out for 5speed swap)

[jlandreth]

If it's a 4-speed,remove the 2 snap rings and slide toward the front of the car