Putting the Dash in

[ashkman]

Hi All, I'll be starting the put the dash back in and of course I've misplaced the screws.  Can anyone guide me on what size they are? I've been searching and haven't found anything. 

 

Thanks,

[esty]

man, grab a handful of assorted sized, get under there and see what works...

 

[conkitchen]

1 hour ago, esty said:

man, grab a handful of assorted sized, get under there and see what works...

 

Get'r dunn 

230 or 220 whatever it takes. 

[albatcha]

I think I remember them being 8 or 10 mm sheet metal screws, I'm leaning more towards 10mm.Length was not that long, less than an inch I think, But length isn't critical here either as long as it's long enough but not too long, so maybe 15mm or so length would be good.

[albatcha]

Almost all the screws in that area of the interior are 8 or 10 mm in various lengths.

[albatcha]

Nevermind I'm stupid, i think I'm remembering using number 8 and number 10 screws, not the mm measurement.

10mm would be a huge screw lol.

Edited August 15, 2020 by albatcha