so far I was able to get this on the differential. One measurement is at the front side of the bolt the other is at the rear. sorry I don’t have a millimeter tape measure. Hopefully this will help.
Almost ready to road test. Since September I've been slowly but surely replacing the rear trans / shifter seals, renewed all the shifter / shifter support stuff, installed new guibo, installed all new brake lines and hoses, replaced all steering box seals, replaced one inner tie rod, under-chassis cleaning and touchup painting here and there, changing oil and filter now (waiting on crush washer delivery today)... need to check alignment; pertronix ignition to be delivered today...
I am re-installing my propeller shaft / guibo on my '72 2002 and I see different torque specifications for "shaft with sliding section" and "shaft without sliding section", however, I cannot find the definition of "sliding section". What does that mean and what do I have? Sorry for my ignorance...
Welcome! Ive been in TN 4 yrs. + in the Nashville area. I got my ‘72 2002 1.75 years ago (my 2nd). As Rob said above, theres a handful of others in this immediate area. Best of luck in your search. This website and its participants are a great resource.
Manufacturer of Vintage Car Parts,MVP,BMW2002,BMW,bmwclassiccars,bmwclassic,bmw2002classic,bmw02club,mvpvintageparts,recreate a legacy
WWW.MVPVINTAGEPARTS.COM
Manufacturer of Vintage Car...
Front Vented Disk Brake Kit (2002) — BMW 2002 Parts
WWW.2002PARTS.COM
If your 2002 has stock (non-tii) front struts, and have struggled with heat-induced brake fade, then this vented rotor kit for you. This bolt-on kit utilizes Volvo 240 Turbo 4-piston Gerling calipers, 1980-1983 E21 hubs...
Interested in the “early under dash panels etc interior, nice shape”.
Would these fit a ‘72?
Also perhaps “FS3 - anadized trim, between b and c pillars, pairs“.
Do you have pics of the above items?
thanks.
Agreed, I don't see any bitching either. As far as I'm concerned, the thread is solely about URO Door Seals (at titled in the subject line), seals which even URO acknowledges need improvement. I don't care who ends up making them right, I just need one 😂
URO's not going anywhere as long as they're profiting from the sales to 2002 owners. Also, URO openly admits to the problems with their door seals (see earlier posts). Customer complaints about parts quality serves to cause improvements by good businesses. Don't know of anyone who doesn't appreciate the parts of good quality URO providea.