Jump to content

its55

Solex
  • Posts

    690
  • Joined

  • Last visited

  • Days Won

    4
  • Feedback

    0%

Everything posted by its55

  1. good idea, I used a small sledgehammer and some twisting!😂
  2. i recently replaced my original carpet and still have my old. i’ll check it out and get back to you.
  3. Personally i believe LED headlights should be illegal; they’re far too blinding.
  4. I see them on the website, any idea which one is needed I would like to do this as well.
  5. i used cheap nuts and bolts that will break easily 😂
  6. in case you weren’t aware, and in case all else fails they are available at Wollathnesh. I bought one there recently
  7. you certain it needs a re-core? Had mine cleaned and repaired here in TN, didn’t cost much.
  8. Sorry for the late reply - here is a pic on the side which shows all the info I'm aware of ...
  9. As usual, all great and useful suggestions! Thanks to all. I'll probably get started on this after next week and will keep ya'll informed.
  10. It appears that I have a coolant leak between the subject fitting (see pic) and the head. Previous owner refurbished the cylinder head and perhaps did not properly install / seal the gasket, I assume. Can the branch stub be removed without removing the intake manifold? Looking at things including the pic it appears that it can. Hoping I can carefully remove and reseal. I know the gasket is shared with the intake manifold. Also wondering if coolant can leak through the stud similar to how studs can leak oil on the exhaust side.
  11. If you’re also considering new, have you checked with aardvark?
  12. Completed my Esty carpet and Recaros installation - that was a job!!!
  13. For those who have installed the Etsy or other carpet, what method(s) did you employ to locate / cut the holes for the seatbelt bolt and seat slider rails knob locations? Looking for suggestions before I screw it up! 😂
  14. There’s a few of those pins inside the transmission…yikes…
  15. got an expander at harbor freight for about $10, works great! Good tip about the tip!
  16. so far I was able to get this on the differential. One measurement is at the front side of the bolt the other is at the rear. sorry I don’t have a millimeter tape measure. Hopefully this will help.
  17. I could try - what measurement do you need? My 02 is all together so I may not be able to get exactly what you need…
  18. As part of my new carpet project, im replacing one of the floor hole covers which was a bit rusty. Also replaced the old fuel line while all exposed.
  19. Started the carpet replacement project! Some nice Esty carpet will be taking the place of the 52 year old dirty stuff.
  20. Sorry, thought all of them were interchangeable. It is a ‘72.
×
×
  • Create New...