choke shaft for weber 32/36

[walkinfool]

Hello, this may be a longshot but I need a choke shaft for a Weber 32/36. I'm cleaning and rebuilding my current one and the shaft is a bit bent. I can order a replacement one from Pierce Manifold but thought I'd see if the community has one laying around for cheaper. 

 

thanks,

Mitch  

[Mike87]

I have one but it is worn and slightly bent as well, although it does work well in the carb cover.

 

Let me know.

 

Mike

[walkinfool]

Hi Mike, thanks for letting me know. do the choke plate set screws still thread/tighten? One of mine was pretty bad and would not thread correctly. 

best,

Mitch 

[Mike87]

I will check and let you know. Also grab a photo or two so you can see it.

 

Mike

[Mike87]

Looks like all the threaded holes are good. I put some socket head cap screws in them for verification. Check the photos.

 

 

[walkinfool]

looks better than mine haha. as long as the choke plates will fit in okay I think it'll work. What do you want for it?

[Mike87]

PM sent. You can also contact me at mike.87@juno.com if you want.

 

Thanks,

Mike