Jump to content

anders72

Solex
 View Profile  See their activity

  • Posts

    9

  • Joined

  • Last visited

  • Feedback

    0%

 Content Type 

Everything posted by anders72

  1. anders72
    Hi! I replaced all my coolant / radiator hoses earlier this summer, used only original hoses and hose clamps. While fixing my brakes a week ago I noticed there was coolant on the body under the radiator where the lower radiator hose is attached. I tightened the hose clamp and hoped it would go away. Now it has leaked some more, maybe about 1-2 teaspoons every day. The car has not been driven, since the has been up in air on axle stands while waiting for new calipers. I painted the radiator when replacing the hoses (including the part where the hose is attached), could this cause a leak?
  2. anders72
    Found that that calipers were rusty and stuck. Planned to overhaul them my self, but they were so bad I ended up ordering rebuild ones from Wallothnesch. Also found the brake hoses were swollen (even though they looked new on the outside), so I have replaced them.
  3. anders72
    You might have both swollen brakes lines and sticky calipers, I had.
  4. anders72
    I've been away for a few days visiting family and attending a classic car show. Found that the brakes work normally when the car is started. After a while they disappear. The car also now drags to the side (which it didn't use to) and the right wheel squeeks. When parked I noticed the wheel was hot. Anders
  5. anders72
    Thank you! I did hear a squaking sound from the left wheel after this. Goes away when I brake. Might be a sticky caliper then?
  6. anders72
    Hi! After driving about 1 hour yesterday the brakes suddenly didn't work on my 73 1602. When I press the brake pedal it goes to the floor, but if I press it again it works as normal. I have been planning to replace all the brake hoses and the master cylinder since it's rusty and the rubber where the brakes lines goes appears cracked. Is there anything else I need to check or replace? Thanks for your help!
  7. anders72
    Drained the coolant and took out the radiator. Was kind of shocked how little coolant there was left in the car, only about 2.5 liters! Cleaned the radiator, it has tons of bugs in it! Going the paint it (only top and bottom part) after I buy some primer and paint. I am a bit unsure how hard I should fasten the engine drain plug. Does anyone know how many nm I should tighten it?
  8. anders72
    Thanks, I've ordered all the hoses for the heater as well. Is there any thread for replacing the heater hoses? Could not find anything about it the PDF shop repair manuel (since it can't be searched, I might have missed it).
  9. anders72
    Hi! I need to replace all the coolant hoses on my 73 02 and have a couple of questions: I guess it would be best to drain the engine block as well? Do I need to lift the front of the car to drain the coolant or replace any of the hoses? (The Haynes manual says the car should be level when draining the coolant).
×
×
  • Create New...