ITB set + manifolds + fuel rail $200

[beast02er]

I have a set of ITB's that I made a few years back along with the cannon intake manifolds and the fuel rail (fits BOSCH injectors). The ITB's are based off of GSXR600 throttle bodies, JB welded to aluminum flanges that allow bolting to DCOE style intake manifold. The manifold holes are drilled out so the ITB mounting bolts can slip through.

Most of the linkage spacing is there, needs 2 springs, the extended tabs are made and there though.

Email if interested. I had these on my 02 and running, I was in the process of tuning when some short or something happened in my MS wiring or board that I never figured out, after about 4 months of getting nowhere, i pulled it all and put the DCOE's back on so I could drive my car.

Won't take a ton of work to get these on a car, most of the hard work has been done, save the money and time and buy these!

$200 + $30 shipping.

Bryan

red73

[rover1]

What size are the throttles 40-45mm?

[beast02er]

I believe 600's are 38mm, which is more like a DCOE when you factor in the choke (takes it down to around 36-38mm), so it is about the right size for a 150hp engine.

[smhheidari]

still avail?

[beast02er]

Yes still available, email if interested

-Bryan

[illegalsmile]

email sent