Flo fit seat rails: welded mounts with bolt holes that align

[BDB]

Hi folks,

I decided to spend some time to weld some tabs onto the original Flo fit seat rails that were installed on a pair of Flo Fits that i acquired based on a member's tip (Thanks!)

As you can see in the pics, I've cut down the original mounts and decreased the height of the rail height. The holes line up perfectly. Bolt down and you're golden.

Selling because they rode a little high for me. Selling for $75 + shipping. These took a lot of effort to get it right!

[adamjspooner]

Do you have any pictures of Flo Fits installed on these mounts? I'm interested in how much higher they'll sit.

[BDB]

Unfortunately I don't. Whta made it tight for me was the fact that I have a big arse wood steering wheel. What I can do though since everything is apart on the oem rail vs these flo fit seat rails. I can compare the height and the height difference between the two

[adamjspooner]

That'd be great. I have a large wooden Personal steering wheel. So, these may not work for me.

[BDB]

ill take measurements when I get home tonite. I'm in CA so check back around 9 to 10pm EST. Ill post pics. Id estimate that ithe rails (measured at the center of the rail's threaded bolt holes) make it 3/4" higher than the top of the oem rails.

[BDB]

adam,

ok here's the measurements. the oem mounting point (top of the oem rails) is about 7/8". the mid point of my welded rails is 1 1/8". see the pics. so difference is only 1/4". what made my seat sit high is the mounting frame on the seat itself.

[chefdog96]

I'd like to buy them. I,ll send you a message. Also where in CA are you located? I am in the bay area.

Markus

[chefdog96]

For some reason I cannot send you a PM.

Please email me at punsalan.markus at gmail.com

[BDB]

Hi Mark,

I sent you an email. If you didn't get it, email me at sizzlerscheesetoast@ GMAIL dot com.

I live in the San Bernardino County in Rancho Cucamonag

Bob

[adamjspooner]

Thanks for taking those measurements. That'll be too high with my steering wheel. So, I'll pass.

[chefdog96]

Bob,

didn't get your email so I sent you one.

Markus

[BDB]

Adam and Chefdog:

Adam, no problem.

Chefdog, I just resent the email via FAQ's email system. If you didn't get it, I need your address to calc shipping. Please send to sizzlerscheesetoast@gmail.com. I'll send you the final cost with shipping back to your specified addy

[chefdog96]

sent. check your spam folder if you don't get it. that's where i found your email.

Markus