Ignition, steering column lock.

[Guest Anonymous]

I have to install a temporary aftermarket ignition switch until I get mine rekeyed, and I need to know what wires off of the switch are what. Also, how do I remove the column lock so I can steer?

Thanks,

-Patrick

(Not stealing a car, I'm going to drive the parts car!)

[Guest Anonymous]

Ah, I forgot I have the manual... any tips though?

[Guest Anonymous]

screws from the back. Take them out and you can start/run your car without a key. I assume you have som way of unlocking your steering column. . . anyway a real easy job.

Cheers!

John N

[Guest Anonymous]

No, I don't. I got the switch out from the manual, but I can't figure out how to get the column unlocked?

[Guest Anonymous]

....rather than co-pilot:)? I have an ignition switch if that helps.

[Guest Anonymous]

The lock to the column is done by the tumbler assy. Its held in place by a soft steel roll pin. Drill it out or pry the lock out. Where the key goes in its about a quarter of an inch at the bottom......