pony69

I also need the dome light pictured above. Is it still available?

thanks

I'm aware of how the lights ground, the issue is the lights operate dimly while not grounded. 

Ok, I've pulled all the bulbs on the blinker circuit (I have the two filament bulbs in front). I wired the front blinker wire directly to the bulb eliminating a possible old housing /contacts issue. I grounded the build as well and the light works as it should, but when I remove the ground the bulb continues to flash but very dimly. Could this be a faulty turn signal controller?

Hi, So I just picked up a long stored '71 this last weekend. While waiting on parts (distributor, carb rebuild kit) I'm attempting to get all the lights working. I began by replacing all the bulbs. I got all to work once I did the three prong flasher mod. Here's the crook. I noticed when I pull the front blinker /running lights lens housing out from the chassis the lights still operate without being grounded. I know this indicates an issue but what I'm not sure. Thank you in advance for any advise on this matter.

Yes, all is sold.

Price:: 200.00

Location: : NY

Nardi Classic 360 mm Steering wheel & hub that will mount to your 2002. Wheel is from the 80's and is almost perfect, just a couple of small nicks. Horn button does not work & needs the horn plunger (15.00 from Crowders http://www.crowderscustomizing.com/Nardi-Personal-PISTONCINO-3-p/nardi_pistoncino.htm )

Shipping is included for the lower 48.

Price:: 1.00

Location: : NY

Just finished restoration and these parts are left over. All prices are firm and include shipping. thanks

Chrome is good but lens is broken.- $30.00

Turn Signals, pair- Chrome is very good - $60.00

Dome light lens - $15.00

Rear vent window gaskets - $50.00

Tail Light Gasket - drivers side, new - $20.00

Trunk Vents - $20.00

Ash trays - $20.00

Front Seat Belts - Works but typically slow and jerky. $30.00

Grab Handles - $20.00

Price:: 40.00

Location: : NY

These have not been mounted since being rechromed. These are off an early '02 bumper that I used only the overriders on.

Shipping is included.

Price:: 100.00

Location: : NY

This is Anton's front bumper conversion kit. I used his kit for the rear bumper and it works great.  I replaced my fromt clip to a euro one so I no longer need this kit for the front. Instructions and template are included.  I will charge the shipping fee , but that depends on where you are located.

Price:: 75.00

Location: : NY

Housing and gauges are in great shape. Out of a '74 I think, not sure though. No speedo. Shipping included.

SOLD - Thank you everyone for your response

Price:: 150.00

Location: : NY, 10956

Kamei Reproduction Spoiler, bought from the following web site -  

( http://www.probimmer.com/Pierre/kamei_repro_spoiler.htm ) Holes were drilled but the spoiler was never mounted. The spoiler is in perfect condition.

Great place to start. I'll update my findings. Thank you

Hi all, I have a '74 that's acting up. symptoms are.... when I switch the turn signal on the stereo turns off as well as the turn signal goes out. Then randomly later the stereo turns back on until I use the turn signal again then poof all goes out once more. Fyi- the emergency flashers work even when the turn signals do not. My inclination is to replace the turn signal switch. Any advice would be appreciated.

Hi, I'm looking for a pair seat sliders for the drivers side on my '74. Mine are bent and will not move. If you may have both pairs (passenger and drivers) I'll take both sets. Please let me know.

Thank you, Forest

Location: NY

Hi, I'm looking for a pair of window brackets. They are the stamped metal pieces with the rollers and track slider. Please see below it's item # 1 & item #2 (slider)

Location: NY

Hi, I'm interested in a set of the black trunk vent tubes. $30.00 shipped? Please email me @ forestwtason@earthlink.net with answer and payment info.

Thanks

I'm interested. Where in Connecticut?

Nice chart, thanks. I should be able to identify the tranny based on the information there. I'll compare and get back with findings.

Andrew, looks like the trans in the link you provided but the measurements are different then the image above. They are as follows. 10.25, 4.75, 2 3/8 & 4 1/8.

The yard also said this may be out of a european grey market car.... I'll look for the date markings you described.

Thanks for your replies. I did find these stamped numbers ( 015766AK ) on the top of the bell housing. Do you think these would be an indication of the date?

Found this Transmission today in a boneyard. They told me it is out of an '83 e21. There are two sets of casting numbers - 242.0.291.01 5.4 225 (tail section) & 242.0.325.00 1.1 225 (inside bell housing). Any help would be appreciated.

Hi, I would take all these items if they are available. My email address is forestwatson@earthlink.net. Please let me know if all or any are still available and I'll pay immediately. Thank You