Jump to content

Russ Keller

Solex
  • Content Count

    55
  • Joined

  • Last visited

  • Feedback

    0%

Community Reputation

6 Neutral

About Russ Keller

  • Birthday 05/01/1870

Profile Information

  • Gender
    Male
  • Location
    Wake Forest NC
  • Interests
    Vintage Radio, older BMW's, Music

Recent Profile Visitors

431 profile views
  1. 62767845271__075798D9-A857-4857-A2F4-14581B7B8CDA.MOV Both sides have nice rust holes in about the same location. Drivers was right under the fuse box. Luckily they didn’t much through any wires.
  2. Both sides have nice rust holes in about the same location. Drivers was right under the fuse box. Luckily they didn’t much through any wires.
  3. After a 3 month wait the hoops arrived. It gave me time ti disassemble and dig for rust. If rust was gold I’d be rich.... Question: how many holes does it take to mount a license plate light?
  4. OK: looks easy just messy. Step 1. Remove cap and circlip from ends. "check" Step 2. Remove old boots and clean out grease as best you can "check" Step 3. Pull cv joints off the end of the shaft. Step 4. Get Hammer and drift and try to beat the cv joints off the shaft. Step 5. Get BIGGER Hammer and destroy cv joints while taking them off.... What could go wrong. I searched and found a couple missing links referring to half shaft, or short axle, etc. rebuilds but have come up with zip. Thanks in advance. r
  5. Mine looked good till I took it off. After shedding 5 lbs of rust, it's much lighter now.... Need something without rust. Standard 2002 non Tii, 1972 short transaxle.
  6. Nothing is an exact match so... OK, going to fab out of stainless or aluminum. Will use one of the 4 mounting bolt locations as the raised bump, the others will be flat heads.
  7. I see spring perches available for other models that look similar even though they are uppers and for other cars. if the cap “hat” diameter is the same and they’re not canted or angled to one side they should work. If there are no replacements available I’ll try those for $11.00 rather than $140 a side for a used control arm that’s needs rehabilitation anyway.
  8. I see all kinds of replacement sheet metal parts but none of these rear trailing arm spring perches. The rest of the arms look great, other than dry rotted bushings. Does anyone know a source or are these a fab it yourself item. thank you,
  9. Looks like mine was baked like a pizza... Need one that's not buggered. Thank you, Russ 919 235-2562 call or text email [email protected]
  10. Looking for a decent drivers (left side steering) grill for a 1972, needs to be shallow. Thank you, Russ 919 235-2562 [email protected]
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.