coloincaalpine

7" front w/0 offfset / 8" rear Hi Dave, Merry Christmas

This car was built by my friend Chris Willet at Sin City BMW and he used my e30 ix as the base.No doubt about it, he has fun with some of his builds. -dq

+1 Hal. This is the way to go. Pitman arm pullers are cheap and most parts stores rent or loan them. Wear eye protection Mike. It should have a mark on it for timing. -dq

Just received this response after asking URO for replacement seals that I received as a gift (no receipt).These guys are on top of this,I mean, above and beyond to gain respect in the community. They have mine. -dq URO Parts Support 41 Replied: 10 minutes ago Hi Dan, since you don't have an order confirmation, please lay out the bags containing your URO Parts seals on a flat surface and place your drivers license alongside one of the labels. Take a photo of the white and blue URO labels (with your driver's license). then remove the seals from the bags and cut them into pieces. Email the photos of labels and destroyed seals to "sales at uro parts dot com" with a note requesting replacements and referencing BMW2002faq.com. We'll then send new warranty replacements at no charge if you're willing to cover the actual shipping cost (reimbursement via PayPal is probably the easiest). Hope that helps out! Drew URO Parts Support

I sent them an email last night. Really don't expect that I'll get replacements as, they were a gift and I don't have a receipt. That's ok though. I still need a pair and will probably buy some of the new ones if their trade in program doesn't work for me. They seem pretty honorable regarding their products and service. -dq

Never saw one like that! What does the ratchet look like? PM me, i have some of those. Dan

Very minor adjustments should be all that you need. When going up in altitude, rule of thumb is add 1 degree of advance per 1000' of altitude. -dq

Contact Chris Willett at Sin City BMW in where else........VEGAS.

I believe my Mom had those on her '87 Chrysler LeBaron?

Thanks Dave U2. -dq

So, let's see who's awake and who's under the influence of Tryptophan. First needy person that can give me a reason AND send a pic of why you need this 2002 spare tire mount, that is in the bottom of the spare tire well......... it's your's for shipping cost from Colorado. Happy Thanksgiving Thank You Again VETERANS. -dq

You need an E21 release bearing. Be sure to replace the plastic pivot pin and there is a spring clip that holds the arm in place at the pivot pin. Also, do new shifter bushings and reseal the tranny while it's out, 3 seals, easy to do now or pull the trans back out in a month. Good Luck, Dan in Colorado

Yeah, Those are no good man. If you send them to Colorado, I'll see that my scrap metal guy gets them. -dq

I have late harnesses individually boxed by VIN. What is your VIN? Dan in Colorado

I have had some luck drilling a small hole thru the plastic cage and thru the plastic bearing cap to get the nozzle to the upper bushing.Also , spraying plenty of contact spray on the armature/brushes,then, keep moving the fan with a long screw driver. Good Luck -dq

PM me Steve, I have one on the shelf. Dan in Colorado

PM me Dillon, I believe that I have one of those in my stash. Dan in Colorado

Hey Ian, Just couldn't stand it Huh? Had to have another one. Congrats, looks like it has plenty of potential. Give me a shout sometime, I have that piece that goes over the blower motor. Take Care, Danny Quigley