ma.jomaa

Solex
  • Content count

    290
  • Joined

  • Last visited

  • Feedback

    0%

Community Reputation

26 Excellent

5 Followers

About ma.jomaa

  • Birthday 08/16/1986

Profile Information

  • Gender Male
  • Location Northridge, Socal
  • Interests BMWs

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. ma.jomaa

    1987 BMW 528e LS1+T56 Swapped

    It is not.
  2. ma.jomaa

    1987 BMW 528e LS1+T56 Swapped

    Up for sale is my 1987 e28 with an LS1 swap with working AC and heat. All work was done at JMP AutoWerkz in Reseda. The list of work done/parts involved is not all inclusive as I will not remember every nut and bolt used to complete the build. Used Parts: -LS1 with around 80K miles. Engine was resealed and a new water pump was installed -Rebuilt T56 Transmission -LS6 intake manifold -Resealed 3.73 Small Case LSD -Euro Bumpers -Euro Headlights -Euro Turn Signals New Parts: -GTO Oil Pan -Pro 5.0 Short Shifter -Aeromotive Adjustable Fuel pressure regulator -New high pressure fuel pump -Chromoly pushrods -CSF Radiator -16'' Spal fan -Water Pump -AC Compressor -AC Lines, AC Condenser and Drier -Heater Blower Motor -Condenser Fan -Diamond Stage II Clutch -Spark Plugs and Wires -Porsche 944 Brake Booster -e32 brake Master Cylinder -e34 M5 Brakes all around: New calipers, Rotors and Pads -Custom one piece driveshaft -Federal RSRR tires in 235/45/17 (Less than 500 miles on them) -New euro bumpers rubber trim. -VDO Oil Pressure gauge -VDO Temperature gauge -Innovate Motorsport Wideband AFR gauge -Custom headers to clear steering box -Engine and transmission mounts -Tie Rods -Upper and lower control arms -Idler arm -Steering Center link -Sway bar links Front and Rear -Rear Pitman Arms -MAP Sensor -IAT Sensor -AC and Drive Belts -Expansion Tank -QTP electric Exhaust Cut out -Custom 3'' exhaust,with mid section muffler, high flow cat, and rear magnaflow muffler. -Euro Bumper brackets Dyno tuned at New Era Performance LLC in Agoura hills, it made 303hp and 330ft/lb TQ at the wheels. Asking price is $18,950 Please don't waste my time or yours with low ball offers. This is a for sale post, and not a survey of whether you agree with what I did to the car or not, lets keep negative comments off the post please. I can be reached at 818-703-2097 Call or text Below is a link to google album of the car. https://photos.app.goo.gl/nCsfu04BUlY0nzy33
  3. ma.jomaa

    Tii Aluminum intake runners

    To the top......
  4. ma.jomaa

    Tii Aluminum intake runners

    Hello, I have a set of Tii aluminum intake runners for sale, these were spares I had sitting in the garage. asking $300. you can reach me at 818-703-2097. Thank you.
  5. Thank you all, I've reached out to Jake and waiting on an estimate.
  6. Just picked up this beauty and thought I'd share with you guys. 87 528e great condition, solid driver but in need of speed. I'm in the process of finding a shop to perform an LS swap. Suggestions are welcome.
  7. Year:: 1975 Make:: BMW Model:: 2002 Price:: 13000 Location: : Porter Rranch, California This is not a desperate for cash sale, I simply need to move on and pass this almost finished project to some one who will finish it and enjoy it more, I got few calls and the first question that were asked were "What's wrong with it", again there is nothing wrong with my 02 I just reached a point where I really don't want to finish it and would like to pass it to someone who will enjoy it. I've migrated to riding my motorcycle more often and will not be needing a project in my life for a while. The highlights: 1975 (no smog for you CA residents) Original Socal car still carries CA blue plates. Original Polaris, 1.5 year old paint job shines great, proper engine out, glass out stripped down to bare bones paint job. -Full suspension rehab, every thing was bought from IE and no money was spared on parts. Bilsitens Sports with cut IE stage2 springs, + stage 2 sway bars. Over $2000 in parts -All new weather stripping all around, door seals, front and back windshield, rear popup windows,trunk seal . -e21 recaros in mint condition, were in storage since mid eighties, replaced webbing with new kit from adrdvark and the seats feel like new. -M42 Engine swap, done professionally by a local shop here in Socal, it was done using JakeB swap kit, the engine was pulled out of a babied 91 318is that had a little over 100K miles, -All seals and gaskets were replaced, -new water pump, thermostat, radiator, and SPAL 16" electric fan, new starter, and clutch slave cylinder. -All new aluminum fuel lines -New Walbro 255lph inline fuel pump -2.5'' exhaust piping, with mid resonator and a high flow muffler -All gauges work, we had to go with VDO electric gauges for the speedo and tach(both fit in stock location) - Brand new AEM Wideband AFR Gauge, AFR reads mid 14's all the time. - VDO Temp gauge. - New brakes in the rear and new pads upfront. -IE stainless steel brake lines. -Underdash AC With all Brand New components, from condenser, compressor, fan, hoses and aftermarket Evap unit. Engine temp does not cross 180 degrees in 95 degrees weather thanks to the 16'' fan and the 12'' Condenser fan. - 2.5'' full exhaust system, with mid resonator and rear muffler (not too loud), but exhaust can accommodate a future turbo. What it needs to be completed: -Finish Dynamating, carpet,headliner, and the back seat reupholstered. -Door cards vinyl is in great condition but backings need to be replaced. - So all together about a $1000 and a couple weekends and you got yourself a resto-moded properly built 02 that will run RELIABLY for many years to come. -No Money was spared building this 02. I will gladly answer any questions you might have, my number is 818-703-2097 Asking $13,000 FIRM. I will take as many pictures of every corner of the car if you're far away and need close ups, otherwise it would be wise to come by and inspect for yourself. Better pictures can be seen at the Flickr album in the link below: https://www.flickr.com/photos/130033353@N06/
  8. ma.jomaa

    1975 BMW 2002 Resto-Mod M42 Swap with AC

    Bumppppppppppppp
  9. ma.jomaa

    1975 BMW 2002 Resto-Mod M42 Swap with AC

    a link with better pictures have been added.
  10. Make:: BMW Model:: 2002 This is not a desperate for cash sale, I simply need to move on and pass this almost finished project to some one who will finish it and enjoy it more, I got few calls and the first question that were asked were "What's wrong with it", again there is nothing wrong with my 02 I just reached a point where I really don't want to finish it and would like to pass it to someone who will enjoy it. I've migrated to riding my motorcycle more often and will not be needing a project in my life for a while. The highlights: 1975 (no smog for you CA residents) Original Socal car still carries CA blue plates. Original Polaris, 1.5 year old paint job shines great, proper engine out, glass out stripped down to bare bones paint job. -Full suspension rehab, every thing was bought from IE and no money was spared on parts. Bilsitens Sports with cut IE stage2 springs, + stage 2 sway bars. Over $2000 in parts -All new weather stripping all around, door seals, front and back windshield, rear popup windows,trunk seal . -e21 recaros in mint condition, were in storage since mid eighties, replaced webbing with new kit from adrdvark and the seats feel like new. -M42 Engine swap, done professionally by a local shop here in Socal, it was done using JakeB swap kit, the engine was pulled out of a babied 91 318is that had a little over 100K miles, -All seals and gaskets were replaced, -new water pump, thermostat, radiator, and SPAL 16" electric fan, new starter, and clutch slave cylinder. -All new aluminum fuel lines -New Walbro 255lph inline fuel pump -2.5'' exhaust piping, with mid resonator and a high flow muffler -All gauges work, we had to go with VDO electric gauges for the speedo and tach(both fit in stock location) - Brand new AEM Wideband AFR Gauge, AFR reads mid 14's all the time. - VDO Temp gauge. - New brakes in the rear and new pads upfront. -IE stainless steel brake lines. -Underdash AC With all Brand New components, from condenser, compressor, fan, hoses and aftermarket Evap unit. Engine temp does not cross 180 degrees in 95 degrees weather thanks to the 16'' fan and the 12'' Condenser fan. - 2.5'' full exhaust system, with mid resonator and rear muffler (not too loud), but exhaust can accommodate a future turbo. What it needs to be completed: -Finish Dynamating, carpet,headliner, and the back seat reupholstered. -Door cards vinyl is in great condition but backings need to be replaced. - So all together about a $1000 and a couple weekends and you got yourself a resto-moded properly built 02 that will run RELIABLY for many years to come. -No Money was spared building this 02. I will gladly answer any questions you might have, my number is 818-703-2097 Asking $15,000 I will take as many pictures of every corner of the car if you're far away and need close ups, otherwise it would be wise to come by and inspect for yourself. Better pictures can be seen at the Flickr album in the link below: https://www.flickr.com/photos/130033353@N06/
  11. Had a great time this sunday, Big Thank you to Rey and Scott for helping me with the suspension and not letting me give up on finding the problem. looking forward to the next gathering.