Sign in to follow this  
Guest Anonymous

Fuel system is hooked up and ignition wires hooked up and m

1 post in this topic Last Reply

Recommended Posts

Guest Anonymous


but I don't have a green wire that the Haynes manual says goes from the ignition switch to the coil. Maybe it is there, but haven't found it yet. I'm working on getting the pics up.

The fuel lines are all hooked up with the electric fuel pump and regulator. The cabin wiring harness is partially hooked up, still need to run it to the trunk. I picked up a battery yesterday and a few other pieces.

I did find out that the switch under the dash was for fog lamps. Not sure why they didn't use the switch that was already there.

For some reason the gas tank isn't fitting quite right. A couple of the bolt holes line up but the two at the rear are off. Would it be alright to drill the gas tank bolt spot to get them to line up?

Anyway I'll be working on it tomorrow some more.


Share this post

Link to post
Share on other sites
You are commenting as a guest. If you have an account, please sign in.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoticons maximum are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this