engine and drivetrain engine bay a/c pics EDIT: for Behr setup.

[colorobo2002]

I'm trying to locate where the a/c hoses go into the engine bay. Anyone got some pics or measurements? I doctored up this photo of Harv's (hope you don't mind) to show where I think the holes are.

[esty]

you have them mark'd as the 2 lower left

[Napes]

I can get you some measurements later today, but where you got 'em marked looks pretty close. It's more critical on the cockpit side than on the engine side. Make sure that's where you want 'em comin' into the passenger compartment.

Bob Napier

Just measured mine (Behr, on a ' 75) and the vertical measurement down to hole center is 1½" and from the outside toward the middle, the first hole center is 2 3/4" and then 2" to the second hole. You want to make sure the first hole in from the outside clears the "elephant trunk" drain hose coming down from above.

[mikem]

Behr, Frigiking, Clardy, Other?

[colorobo2002]

I'm trying to locate the holes so that I can route my efi lines through the firewall elsewhere.

[Arizona02]

the firewall, then you will know where the holes have to be.

[dirk2602]

Hope these pictures are helpful. It's a Behr in a 73 tii.

[Harv]

I doctored up this photo of Harv's (hope you don't mind)

Don't mind at all. Just buy me a beer at the Pyramid (sp?) brewery the next time I get to SAC.

John

[colorobo2002]

(nt)

[Jimnh]

I have a copy of the Behr installation manual, which includes a template for making the holes, which I could fax or mail to you. Email me if you're interested: jmorris@orr-reno.com

[colorobo2002]

is this what you have?