Was away for 3 weeks and had some work d. . .

[Vroomer]

Was away for 3 weeks and had some work done on my 2002:

New 3-Core radiator

New Alternator

New Fuel Pump

New manual choke cable

New 02 Again Exhaust Manifold

Just a small radiator leak, needs a new dash circuit board, and a not good rotating metal on metal noise (if it goes aways, it's all good, right?!).

Other than that, she's 110% better!

[Beaner7102]

Just a small radiator leak, needs a new dash circuit board, and a not good rotating metal on metal noise (if it goes aways, it's all good, right?!). Other than that, she's 110% better!

Just turn the raido up, or drive faster so the wind noise drowns out the metal on metal sound. Ha ha ha. Keep up the good work. Beaner7102

[ryanOC]

details on the exhaust manifold?

[Gordon]

Vroomer,

If Rob is at his shop tomorrow, I'll be there to finish parting out the 91 318i. Did you see that in his lot? I drove it like that back from Santa Margarita, what a ride.

Give me a call tomorrow

G-Man

[cj]

I saw your car at Rob's. It's looking good Vroomer. I too installed the '02Again header and it's definitly a nice piece. I did'nt make any changes to timing or air/fuel ratio on the CIS as I wanted get a seat of the pants comparison to the Tii manifold. It definitly pulls quite a bit harder. I can't wait to do the dyno pulls!

Cris

[Vroomer]

I saw your car at Rob's. It's looking good Vroomer. I too installed the '02Again header and it's definitly a nice piece. I did'nt make any changes to timing or air/fuel ration on the CIS as I wanted get a seat of the pants compro to the Tii manifold. It definitly pulls quite a bit harder. I can't wait to do the dyno pulls!

Cris

Cris, I noticed that the car just seems to 'breath' better. Like the conjestion is gone.

I saw the prototype's dyno results. I can't wait to see the production results.