Where do I apply BFH??? installing 5-spd...

[winstontj]

Where do I apply the BFH? Should I measure back to where the slave is? Is the tunnel narrow at the end of the slave or elsewhere?

TIA,

TJW

[jgerry2002]

see www.my2002tii.com there is a good pic on his website.

[winstontj]

I measured, and have that open on my laptop under the car. I don't know why I feel so badly about bashing the Sh&&&**** out of my car but I do. I finally did it and decided that I can always straighten from inside after it's installed.

Thanks though....

[jpcapoc]

I just did mine a couple of months ago. I don't remember putting much thought into it. Just measure by whatever method is convenient. It won't matter if you're off an inch or two. You don't need to move the metal very far. A couple of blows should do it, not too hard!