Jump to content

Recommended Posts

  • 2 weeks later...

alpina 2002 header never had slip joints, they were gas welded one piece unit, the one I posted was taken off a documented Alpina 2002 with side draft webers in about 1990,  I quoted $900 , hpc ceramic coated inside and out with a 2" v band at the first muffler, it can be built as stock or larger primaries and down pipe, I have been building headers about 20 years , I can provide a picture of headers I built for my euro 635csi  Bruce Mtuner

 

 

 

  • Like 2
Link to post
Share on other sites

yes I built a large tube equal length system for a s14/2002 the floor on the passenger side had to be raised for room for the header, if you want a 6 into two collectors, into a single exhaust , the hammer will be needed the 2002 does not have a lot of room, a dual exhaust system would be better but getting past the rear sub frame will require some work

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...