Jump to content

new steering idler bushings


Recommended Posts

Installed new steering idler bushings, but the bushings don’t stay fully pressed in; they move back out a bit, especially the bottom one. (They were pressed in with a threaded rod.) When the top nut is tightened down enough to insert the cotter pin, the arm movement is extremely tight. Up until then, it spins freely. Suggestions?

assembly04.jpg

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.