Spanish Weber 45 DCOE 152 Carb For Sale

[Mark92131]

Price: $350

Location: San Diego, CA 92131

Description:

I have a slightly used single Spanish Weber 45 DCOE 152 Carb for sale.  This is the same carb that comes with the Lynx manifold in the Top End Performance Kit, (https://www.racetep.com/manufacturer/carbs-and-injection/weber/conversion-kits/bmw-2002-320i-m10-engine-single-sidedraft-dcoe-conversion-kits.html).  I ran it for about 500 miles and it performed beautifully.  I swapped it out for a Weber 45 DCOE 152G thinking that would fix my idle transition, turns out the fix was converting to the top linkage instead of the cable linkage supplied with the kit.

 

The carb comes with DCOE 45 Air horns and has the following jetting.

 

Air Correction - 180

Main Jets - 155

Idle Jets - 60 F9

Chokes - 36mm

 

$350.00 + Shipping, I take Paypal.

 

Thanks,

 

 

Mark92131

 

 

Edited May 18, 2019 by Mark92131
Correction

[SaharaX2]

Nice carb. Someone will like it

I just completed the Lynx manifold install and am enjoying it a lot.
I had issues with top linkage and went back to the TEP cable which works perfectly with a shortened cable housing.

What top linkage did you use?


Sent from my iPad using Tapatalk

[mbb]

PM sent.

[Mark92131]

2 hours ago, SaharaX2 said:

What top linkage did you use?

 

It took a while, but I sourced all the parts I needed to get a smooth operation without binding.  The key was extending the lever closest to the firewall so it matched up with the normal travel of the throttle rod on the pedal box and a good return spring.

 

 

[SaharaX2]

I tried that, but instead of the 12” rod, ideally you need a 15” rod to get back near the firewall so you can use the stock throttle rod.
Because I wanted to drive the car, I switched back to the supplied TEP throttle cable. I did shorten the housing a little to make things fit, but it works so smoothly that I have no reason to go back to the top mount linkage.


Sent from my iPad using Tapatalk