Jump to content
rapandi

Flywheel mark - fitted position

3 posts / 253 viewsLast Reply

Recommended Posts

Hi team

 

I need some direction. I am About to pull the flywheel and the factory manual shows a notch marking the position of the flywheel. I don’t have notch on mine so do I need to mark This? Do I do it with just centre punch? 

 

I have temporarily marked it with it with a torque marker 

 

Raj

 

566E5E48-1CFE-4553-A18F-5771000351BF.thumb.jpeg.e58d440160903b7998231e657c64f8de.jpegA743F8A1-69F6-4501-B082-70B0494CB2DB.thumb.jpeg.014e3f5bf3ea810b35e8cfdb4f24f1df.jpeg

Share this post


Link to post
Share on other sites

The flywheel is keyed to the crankshaft by means of a hollow dowel pin in one of the bolt holes.  That particular hole is oversize so the flywheel only goes on in one orientation.

 

I only know this because the good folks on this FAQ board informed me thusly, recently :-)

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.




×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.