andreb

Crank pulley nut and wave washer needed, M10 engine

3 posts in this topic Last Reply

Recommended Posts

FWIW: I think the output flange nut from the transmission is the same thread and 30mm socket size. I don't have any of these to offer you, but I will offer some unsolicited advice: Use a torque wrench to install that nut. Buzzing it on with an air gun can lead to catastrophic damage of the crankshaft. 

Share this post


Link to post
Share on other sites

Thanks Paul. Maximilian Imports is getting some from Germany. They are also available on McMaster Carr. Appreciate the advice but I torque everything and only use air tools to disassemble things. Plus the motor is in the car so not a lot of room to put the rattle gun on it.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now