Sign in to follow this  
Guest Anonymous

Wiring the Pull-Up Hazard Light to Run Fogs?

2 posts in this topic Last Reply

Recommended Posts

Guest Anonymous

Hey all,

I'm parting out a very rusty early 71. It has the pull-up hazard switch on the far left side of the dash.

A lot of parts including this dash are going to go in a 72 agave car.

This 72 got wet or something and thus, sometime during the course of its life....the interior was replaced with squaretail pieces. This includes a now-cracked 1 piece dash.

I know the 3-piece dash isn't stock to the 72.....but it's what I got.

I'm about to pull the wiring harness out of the 71.

Any ideas about how I can wire up the pull switch to run foglights on my 72 would be great. Anyone ever done this sort of thing?

Jerry Curry

Salem, OR

Share this post


Link to post
Share on other sites
Guest Anonymous

terminal (where the "inlet" wire that feeds current to the switch is fastened) and one more terminal that is not hot when the switch is off but is when the switch is pulled. Note that the switch is rather bright when it's illuminated, so you might want to put some kind of small lens inside the bulb access cap so it won't be blinding at night...

Mike

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this