Jump to content
Sign in to follow this  
Pottsy

Rear Sub Frame Rust Repair

1 post / 1828 viewsLast Reply

Recommended Posts

Due to structural rust I am about to rebuild the rear rocker/qtr-panel area and rear subframe mounting area on my '02. I am doing the welding and fabrication myself, with a MIG.On one side rust is only visible from the top (under the seat), but the other side it also shows through on the underbody and the subfrrame is completely rusted off the mounting pad.  I am concerned about maintaining alignment of the subframe mounting pins if I have to fully remove the mounting pads. (However the area where the pin goes through the body is in good shape on both sides.) I have searched the archive and websites on this, have not seen much specifics.

I would like to hear from someone who has done this particular job before--any hints/tips/tricks/cautions/photos and other insight would be very helpful. Thanks in advance

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  



×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.