Jump to content

5 posts / 786 viewsLast Reply

Recommended Posts

(edited)

I brought my 215mm flywheel in to be resurfaced today. The shop looked up the specs and said the step should be .011 of an inch. Mccarthy's book says 15 thou. What should I have it cut at?

 

...edit - original post said .110, should have been .011 

Edited by peterschop

Share this post


Link to post
Share on other sites

.110" would be nearly 3mm, that's definitely not correct. 0.015 to 0.02 inch would be ok, that's around 0,5mm.

 

  Tommy

Share this post


Link to post
Share on other sites

Oh, I put the decimal point n the wrong place. The shop said .011, that is ,279mm. I could tell him to .020. I just don't want to take off too much.

Share this post


Link to post
Share on other sites

In my experience, you will be fine at .020.  It's not super- critical, and modern pressure plates have a lot more travel

than the thing they spec'ed in 1966!

 

t

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.




×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.