Jump to content

Cap/clip That Holds Fan


Recommended Posts

Fran,

 

I suspect the clip/bushing is long since NLA. I just attached my fan to the shaft of the heater motor this weekend. I used a metal bushing with a little allen set screw on the bottom, placed the fan on top of it then took a plastic bushing and put it on top. Then I epoxied the whole thing. It's on very snug with no wiggle room. 

 

I found the parts in the nuts and bolts section of my small local hardware store. (I also bought a bunch of other options but this seemed to hold the most securely even when compared to metal bushings with set screws on both bottom and top). Probably cost $1 total.

 

Here are some pictures of my final product. The hardest part was removing the old busted bushing, heat gun certainly helped.

 

 

 

52bewy.jpg2hx6hyv.jpg

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Upcoming Events

×
×
  • Create New...