Jump to content

My New Serious Engine Is Taking Shape


LimeySteve

Recommended Posts

  • Replies 39
  • Created
  • Last Reply

As recommended by Jeremy at IE I handed over my block to Russel at Steve's Imports in Azusa, I could not be any happier with the results.Knife edge ground lightened crankshaft, lightened flywheel, shot peened re sized rods ,IE pistons all fully balanced.10.5 :1 compression as I drive it every day , I should see the benefit of my 292 cam & twin 45 Dellortos now :) I pick up the assembly tomorrow .   

 

 

1175541_167165653470058_557953673_n.jpg

Link to comment
Share on other sites

That is very nice. Very. I like the knife-edge crank. There's something intoxicating about a fresh motor.

 

And as to the gas question above, I have a very similar motor in my car, and it runs fine on the 92 we get up here. It runs slightly better with an octane booster (off-road, of course, just in case the NSA is looking). 

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.


  • Upcoming Events

×
×
  • Create New...