Jump to content

floor pan metal gauge


Guest Anonymous
 Share

Recommended Posts

Guest Anonymous

I can't wait for the floor pans to arrive from Germany. Going to fabricate my own. going to pick up the steel early AM tomorrow. Should they be 16 or 20 Ga. Thanks

Link to comment
Share on other sites

Guest Anonymous

the portion i cut out was replaced with 20ga, but the stuff that was in there was a bit thicker, so I'm pretty sure it was 18ga. Odd though, it almost seemed to be variable..like 20ga in some areas, and 18 ga further up. weird.

if you are making the full, bottom (flatish) area, I would maybe go 18, otherwise, just 20ga.

then again, i am new at this, what do i know??

btw, the rocker is 100% in baby!!! wooohooo! all that is left is the 1/4 panel patch, which will be a bitch, because my donor piece has some rust on the bottom so i will have to 'patch the patch

off to race weekend, back monday!

MK

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Upcoming Events

×
×
  • Create New...