So i made new valve tool that has individual rods to push valves out to fit a cam. It worked well. New Eibach double springs in. Old ones had lost about 3-4 kgs. Ti retainers. Seat pressures shimmed to 46 kg. At 11 mm lift they have about 90 kg. New KM rockers went in. Old (and earlier cast) had somewhat wear in them so it was time to change them. Also newer cast is lighter so that’s a plus. Adjusted rocker lash to 0.1 mm. Valve clearenses set to 0.25 mm. My valve press is pretty lame looking but it works. Have done all my M10 & S14 valve assemblies with it.