Well the Backlog of 02's slowed me down a bit but now the shop is making it happen.
The subframe and Transmission tunnel were pre-cut so the motor could go up and get positioned.
first lift showed that the Intake had to com off for a rough location, once that was done we installed the Intake to get the position dialed with the dimensions bianchini provided.
Nice amount of room for the Radiator and Puller Fan
It was tight but the Intake went on
Coolant hose return clearance looks good
Lots of room for Header
From the bottom we're within the last 1/4" of Fitment
Looks like we may come down an additional 5/8"
Overhead view from Exhaust side
Moises says with any luck the motor Mounts will be done today