Jump to content
  • entries
    126
  • comments
    307
  • views
    28,735

Final Fender Fitting


adawil2002

2,177 views

With how twisted and bent the nose was and how much work it took, I'm super happy with the results. Final panel fitting today before epoxy priming. Had to correct the fender/door gap as new sheetmetal needed quite a bit of work to fit properly. Of course the top seam of the fender to nose will be welded as the factory did.

 

Bumpers came back from the chrome shop. 

3:4 body lines 1:18:18.jpg

Final body line check 1:18:18.jpg

Newly Chromed Bumpers.jpg

6 Comments


Recommended Comments

The trailing edge of the fender is supposed to be proud of the door gap to reduce wind noise, as I had gleaned.

 

Is it?

 

BTW this is why some photos make it appear the fender knee trim is out of alignment.

Link to comment
1 hour ago, ray_ said:

The trailing edge of the fender is supposed to be proud of the door gap to reduce wind noise, as I had gleaned.

 

Is it?

 

BTW this is why some photos make it appear the fender knee trim is out of alignment.

 

I cannot tell from the pictures. I'll be sure to look on my next visit. 

Link to comment

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Upcoming Events

×
×
  • Create New...