Jump to content
  • entries
    7
  • comments
    4
  • views
    3,453

Cast Distributor Delete Plate


Orange Claw Hammer

1,827 views

 

So, this project has been on hold for a while as my next big step is to really learn how to properly tune MegaSquirt, and I just haven't had the time to commit to that.

 

But, I had a couple hours today which I spent casting a proper delete plate for my distributor. This is my first sand casting using a core (to create the hollow for the cam end).

 

m10_efi_engine_dist_delete_1.jpg

m10_efi_engine_dist_delete_2.jpg

 

You'll see there's a little divot at the upper left. This is where I can drill and tap for the oil pressure sender, although I may end up moving that over to the oil filter housing.

 

That's it for now.

 

Jesse.

  • Like 1

1 Comment


Recommended Comments

You should put the pressure switch in where you have marked with the divot, as that area has the lowest oil pressure (furthest from the pump). Our .02 cents.

Link to comment

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Upcoming Events

×
×
  • Create New...