Cardboard distributor & housing
With all the CA rain and other distractions I have been back sliding on this build. Today I went forward.
Not finished but progressed enough to add an entry. All the parts I have been building thus far are still rough. They will all go through a clean up stage with light sanding and finishing with the X-acto knife etc.
The dist shown is only the outer housing shell. Plan to have the cap, clips, rotor, condenser, and those fine details like on the real deal.
Enjoy.
4 Comments
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now