| |
|
Date: 10-14-05 06:57
From: tkent02
Subject: Finally, the five speed is in....
|
|
|
Just need to adjust the length of the tower support and get a few guibo bolts, but it's all in.
Pics will be on the new faq tomorrow, it's in there a little differently than most.
|
Date: 10-14-05 08:36
From: bergie33 in Sandy, UT
Subject: Length of the support...
|

|
From www.bimmers.com/02
"Conversion Procedures
If you are installing a close ratio transmission, then you can opt to purchase the shift platform and linkage from BMW, or shorten your old one by 3.125 inches. If you are installing an overdrive transmission, then you will need to shorten your old pieces by 3.5625 inches. To do so is simply a matter of cutting the old platform at the box section portion, and remove a piece that will cause the platform to be 3.5625 (or 3.125) inches shorter when welded back together. Don't forget to account for the width of the saw blade! BTW, the factory pieces are modified exactly this way -- they are cut and welded. The shift platform brace also needs to be shortened. The appropriate length for the brace, for the OD installation is 210mm as measured from the center of the bushing hole to the platform hole. A brace mounting bracket also needs to be fabricated to mount the brace onto the back of the transmission. The 320i transmissions do not have a provision for the brace. One of the 13mm rear cover bolts works as a place to mount the bracket. "
Hope that helps.
Karl B.
|
Date: 10-14-05 11:40
From: tkent02 in Littleton, CO
Subject: Tried several times to do that, no workee...
|

|
I'll try it again.
Hey, it works, thanks! _________________ Tom
Something always leaks.
| Description: |
|
| Filesize: |
65.47 KB |
| Viewed: |
41 Time(s) |

|
|
|
|