Search found 38 matches

Theres a 71' on craigslist in Santa Rosa, guy is asking a 1000 bucks and the car runs. Looks a little ratted, flat black, but hey it runs and its a better starter than mine was. check it out.

htt ...

what floor pans do you have and how do they look??

Where are u taking it in Sonoma?? I'm in Santa Rosa.

Fortunately for me, i'm able to drive the 63' Nova SS whenever, because of the track and outside drivers schools.

A couple of years back I did a Skip Barber course down at Laguna Seca. In the class there were two groups of parents with kids, each kid just turning of-age to get a license. To this day, I can't deci ...

I took all of them off on mine. Then found some sheet metal around the same gauge as the body metal and tacked them in place. Then turned down the heat on the welder and added gas to seal the patch ...

Theres is one here in Santa Rosa too. Its Empire Sports Car Association, season over, of course, but we start up in may i think. I'm gettin my 02 ready for the track. If its more reasonable to driv ...

You can check out Konig. They make a nice set called the Rewinds and come in gun metal and silver. I'm planning on gettin a set for my O=00=O

Ya i almost went that route with a 315 but did something completely different

Welcome to the O2 world. I'm in the same boat u r in. I'm 19 and goin to school and am currently in the process of doing a massive engine swap that probably disgraces the Bimmer Gods. My car has rust ...

I have been meaning to check the vin on my car but haven't found a site that takes the 7 digit vin. Help please.

Looks like one from the bay area on craigslist a few weeks back...can't be sure thou

More progress. I got front and rear sway bars from STSuspensions and have on order Eibach lowering springs. Have one side of the motor mounted need to figure out the other side. Finally got rid of t ...

Looking for 320i axle shafts half shafts

Yes i would! $250. It really just needs to be put in and fire up.

Ya definitely will sell just the motor. 300$???

I have an M10 motor with a 4 speed manual trans. Had a recent valve job, new water pump. It has a one barrel carb on it now but i also have a 2 barrel carb and manifold for it. It ran good before we ...

ok.. will do when i figure out how to transfer it to the comp.

Not yet. We pulled it and i have a video of it running on my phone. it had a valve job before i got the car which was about 3-4 months ago. it has a new water pump and runs pretty good.

Finally making good progress on the 02. Non of that purchasing crap off the internet, not to say i don't like it, but its not work. We took the 2.3 16 today and cleaned the hell out of it so there i ...

Need a rack and pinion setup for my 02. Any one have any ideas??

GOT THE MOTOR AND TRANS PULLED TODAY!!!!

finally some progress. Motor and tranny 4sale just message.

1972. Runs good, new water pump and thermostat. Recent Valve job. Clutch feels good, trans. shifts fine. Complete with radiator and extra parts. Pulling it out, now.

Chuck or Tyler 707 578-8309

...

1bbl carb, runs good! Recent valve job, new water pump and thermostat. Comes with good four speed transmission. Clutch feels fine. Hear it run before I pull it! I also have a 2bbl carb, manifold and a ...

1bbl carb, runs good! Recent valve job, new water pump and thermostat. Comes with good four speed transmission. Clutch feels fine. Hear it run before I pull it! I also have a 2bbl carb, manifold and a ...

yup just the motor and trans for 600 bux

185 hp out of a four banger and a small light car like the 02 would be pretty fricken fun. Plus, i think even without the super charger out of the slk i could tune it to aroun 200. I think the motor a ...

Not sure how much it weighs, but the engine, trans, harness and all were $600 with a fresh valve job. My uncle has a supercharger off of a 230 SLK and he seems to think he can make it work on this mot ...