Search found 29 matches

before the first 2002;
i am 44 now,
bought the first car when i was 12
1965 lincoln
the rest of the list up to the first,
two '65 lincolns
63 t bird
65 t bird
73 cutlass X3
76 toyota
77 k c ...

Hi,
if you are having problems with the fuel
filter you should remove the pressure regulator.
then you should put CLEAR in line filters before
and after the pump. the filters are for VW bugs
a ...

Hi,
i only have a recommendation
for getting a lift. i called a few
local lift service shops and asked
if they had any used lifts. most
did have at least two choices.
and the average install ...

Hi,
the most likely culprit is that the radiator
is restricted on the inside. but, you should
also check that the front of the radiator
is not plugged with dirt or leaves.
curtis ingram on th ...

Hi,
i need the ignition switch which is in the collumn.
it is very easy to remove. a small jewlers screwdriver
is what is used to back out the red painted head of the
flat screw type set screw. ...

Hi,
once you have bleed the clutch system of it's
air bubbles, you usually will not have more problems.
this is because the clutch slave cyl. is fed from the top
and therefore the bubbles trave ...

Hi,
have you replaced all four (4) flexible
brake lines? if you have not then do this first.
next make sure that the brake pedal ACTUALLY
does return all the way. also check the return
spring ...

Hi,
have you replaced all four (4) flexible
brake lines? if you have not then do this first.
next make sure that the brake pedal ACTUALLY
does return all the way. also check the return
spring ...

any pictures?
i'm in philly does it roll
or slide?
how are the wheel house
in the back?
thanks
stone

Hi,
if in fact your car has the original
rear diff. it is a 3:45 rear. this was used
because the 72 has more power and
therefore could pull the car with a
taller rear ratio. it also allows t ...

Hey,
i see you are selling your car.
i have an 1984 300 d that i would
trade if you are interested.
call me to talk about it.
215.520.6718
stone

Hi,
you may find that a few people are located
just outside dc in arlington and fairfax county.
i have a small shop in philly if you need something
e-mail be back if you would like too.
stone

Hi,
usually this rough run is a sign of the points slipping.
unless of course you have an electronic ign. so take the
cap off and reset the points. even if you think that they
are fine reset ...

Hi,
i am in the same situation.
BUT i think that i have found a
solution. 1996-1997 only Passat VW,
60MPH=60MPG, these cars are hardy and
are fun to run. they cost from $3500
to $8500 for a ...

Hi,
i have installed many of these sets
for customers. you are in fact missing
a bushing that goes on the shaft.
when i got them they were always
loose in the packing and not yellow-
chromate ...

Hi,
the oil that you see is coming from around the
exhaust stud. the stud appears to be too far threaded
into the head. remove the head cover and check to see that
the stud is flush with the i ...

i should have more than one in the
shop. call me and we can search
the place.
215.520.6718
stone
stone racing co
center city phila pa

Hi,
how much for the rear bumper
with all the brackets?
thanks
stone
stone02 at verizon dot net

Hi,
that is an old Zender kit
from the 80's.

i either need a welding hat or
a hair piece to protect that patch
of exposed skin.
DAMN THATS BAD
stone......

Hi,
i would like them.
your post dosen't address
how to complete the
deal.
e-mail me please
stone02@verizon.net
thanks
chris
stone racing co

Hey,
your in my scrouge zone.
it sounds like you may have some good
stuff. post the inventory please.
if you change your mind or need
help, let me know. thanks
stone
stone racing co
philade ...

Hi,
all that a relay does is carry power from the battery or other
source to and item that needs power. the relay usually has a fuse
on the control side and or the ground side. additionally, ...

Hi,
yes there is a paper gasket under the aluminum
holder for the rear main seal, it is a horse shoe shape.
also buy a new oil pan gasket. additionally, under the
flywheel there is an oil galle ...

stone02@verizon.net
try this, its the same
as in the profile.
thanks

stone02@verizon.net
try this, its the same
as in the profile.
thanks

Hi,
that is the newer style eyelet.
if you can find the old style it is all steel
and much heavier duty. look for one in
any clutch car. the eyelet size is a larger
diameter, outside. and ...

Hi,
if no one responds soon
call the shop and leave a message,
or listen to the mesage and then call me.
i am not in the city this week but i
beleive that i have a few good ones for
use most ...

Hi,
the studs can usually go in hand tight as above. sometimes
you have to double nut the stud and run it down to the shoulder.
loctite is okay. on the upper studs the hole goes thru to the ...