Search found 815 matches

Well, typically your engine number is the same as the car's VIN.

If your block says 278... that IS a valid 74 Tii vin number. As long as the body matches that same number you just provided it is i ...

Mike,

Good info. Thanks.

Sounds like Bluedevil has what I am looking for. It is indeed grey.

I don't know how to PM you here but if you can just email me that would be great. Let me know w ...

There are several options.

Some folks just take a long hose and point it down out out past the tranny to let the breather vent out underneath the car. I find that is messy, though.

Some just pu ...

Anyone know what the part number is for the rubber spacer ring? ETK does not show this for the US spec headlights.

This part exists between the headlamp chrome-ish trim ring and the grille. So, y ...

Dig the wide angle pic of the group. Still love that red car on the far left...

;P

Mike Pugh looks cold(?) meanwhile Humberto is wearing shorts!

You'll have to remove the door panel.

Once that is off peel back the acella film (if it's still there).

On the outer edge there should be a phillips screw - undo that.

On the inner handle ins ...

kick ass!!

Betcha RIMSPOKE's will still blow this one away...

Thanks Bill.

Good tips. Thanks guys.

I think I will just clean it up like I thought about and put on either Eastwood or POR-15. If I recall there is a black POR-15 so that will give it a nice look underneath.

Car is beginning to show some light rust on the undercarriage. No holes or rot, just rust but it is starting to become 'textured' so it is likely beginning to progress.

My thoughts are to remove i ...

The lead on the left is your main harness into the car and your electrical system. The one on the right goes to your starter.

When relocating to the trunk you have several options. Find an existi ...

For the most part with some minor differences. You are already aware of the 3 hole versus 4 hole output flanges.

Shifter platforms (early and newer) can be swapped around if needed between the old ...

Hmmm...

Trivia: The "L" is short for "Ladung", which is German for electrical charge :)

Your alternator is clearly not happy. We'll start with the easy stuff. Check for any loose connections ...

You are the only other person I know now with a Tampico car. There is one fellow with an 1800 that races it but I have yet to see another 02 with Tampico.

Mine is originally Tampico. Did you jus ...

Esty,

Devo1's diagram is correct. This is the recommended installation. 3 should go one way and the other 3 should face the other direciton. However, I have seen it installed the way you show pl ...

You can do all of the above with enough time, labor and money.

In my opinion you would be better suited to keep a 318is as a track car since you don't really want an 02 for what it can do with its ...

Wiper delay relay only kicks in when you pull back on the lever. Check your stalk for ground and dirt. Clean that up first.

Next, check your wiper motor. On your car you have a separate switch. ...

You probably just need a new rubber gasket or a thicker one.

Buy a gasket or buy a new cap and take it off of that. You can also bend the the catches a bit underneath the cap to make for a tight ...

Here's a pic of mine. I had installed one back around 2001/2002 on my Tii.

Just give Jim Rowe a call. He's a pleasure to speak with and very knowledgeable. They'll get you what you need. He'll ...

SEX-E!

Almost like poetry in motion. Well, almost in motion. Not totally up and running yet is she? Get 'er done.

>;P

I thought she sat higher than that before. The stance is wicked but it ...

Airic,

There are still some additional details you could include on here that would be of interest to potential buyers.

1. Color
2. Condition (any rust?)
3. Interior (if any) included? Condit ...

Nice work.

Just be aware that since you stripped off the anondized finish on there they will dull and fade periodically. You'll have to buff them up once in a while.

But, it beats spending hund ...

As mentioned, bolt length/looseness or possibly a slight bend on your trans' 3 hole output (although you'd have other problems from that since the driveline would not be straight/balanced).

Another ...

Not mine. No affiliation. Just sharing as I came across these on VW vortex...

supposedly on a 2002 formerly.

http://forums.vwvortex.com/zerothread?id=3719791&page=1

http://i10.photobucket. ...

email sent.

Just passing it along. No affiliation, blah blah

http://allentown.craigslist.org/pts/652136917.html

Located in SE Pennsylvania

Is the hissing coming from inside the car where the actual brake pedal is or outside?

If outside at the actual brake caliper it's possible you have blown a brake line and fluid is spilling out caus ...

Jeff,

I may be able to help you. Email me offline. Perhaps even a trade of some sort could be in order...

Perfect.

You do everything right and have impeccable taste. One of the finest 02's on and off this board. Hands down.

Matt Cervi, Baltimore Duke Blue 02

heh heh... nice! poor Matt will never live that down.