Jump to content
  • entry
    1
  • comments
    6
  • views
    4,114

1976 BMW 2002 Twin DCOE Turbo Project


POKTROKT

3,074 views

I figure I should start a blog now that the engine swap is under way and I have collected enough photos to satisfy the masses.

I (and as far as I can tell, many others in this forum) am a VW/Audi person but more importatnly a car person, I can appreciate all... well most... brands and models. Without going into too much detail I have had my share of VWs and Audis.

I sold my project Audi Coupe Quattro after thinking I didn't need all the early 90's gizmos in a project car, I did like the car but the list of options is through the roof; from a heated door key hole to the 8 way heated seats.

Good bye Audi Coupe.

gallery_44285_33_48656.jpg

I was looking at E21s and 2002s and came across this E21, it was someone's project and the story was that they acquired an engine and bits from a E21 race car and planned to run those parts on this one. They dropped the motor in and that was the end of the project, with another project underway they liquidated this car, I got a great deal on it.

Hello E21

gallery_44285_33_120476.jpg

gallery_44285_33_16018.jpg

gallery_44285_33_80609.jpg

The E21 was a wreck, it would take thousands just to get the car on the road, I knew going into it I was buying the car for the motor to do a swap into a 2002.

Fast forward a few weeks and I came across this car on craigslist, it is a 1976 California car living in a storage unit in Michigan, the guy I bought it from was getting a divorce and really needed to get rid of it. The car was originally fjord blue but you can tell it has had a really bad paint job, the paint is faded and peeling off and it is showing some rust but the floors are solid, also there is some bondo but I don't know to what extent... I guess I'll find out if I ever decide to paint it.

The car is bone stock, no modifications other than some fog lights.

gallery_44285_100_56395.jpg

6 Comments


Recommended Comments

I've been looking forward to see this project.  I too have a Cartech setup, be curious to see how it goes for you.  Mine is in pieces, I'll be going with ITB's instead of the carbs.

Link to comment

any updates on this project i cant wait to see this thing finished

Engine is in the car but when I fired it up it ran very rough, found out cylinder 1 had no compression. Changed head gasket and tried again, fired up but ran rough.  Checked air fuel with a wideband and it was running lean, very lean.  Took the carbs apart and cleaned them, in the process of putting them back together. 

Here is a taste

med_gallery_44285_100_790230.jpg

med_gallery_44285_100_728720.jpg

Link to comment

A tad bit jealous...my car lives in California and I have to be careful of any mods, lest I cannot pass the smog emissions test. :(

It looks like a great project, cannot wait to see the result.

Link to comment

A tad bit jealous...my car lives in California and I have to be careful of any mods, lest I cannot pass the smog emissions test. :(

It looks like a great project, cannot wait to see the result.

Out of curiosity, with all the smog regulations, how does anyone register hot rodded cars in California?

Link to comment

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Upcoming Events

×
×
  • Create New...